Recommended Test Equipment - Keithley DMM7510 Calibration Manual

Model DMM7510 7½ Digit Graphical Sampling Multimeter Calibration Manual

Recommended test equipment

The following table summarizes the recommended verification equipment. You can use alternate
equipment if that equipment has specifications that meet or exceed those listed in the table below.
Test equipment uncertainty adds to the uncertainty of each measurement. Generally, test equipment
uncertainty should be at least four times more accurate than corresponding Model DMM7510
specifications. The following table lists the uncertainties of the recommended test equipment.
Manufacturer
Fluke
Fluke
Fluke
Keysight
Technologies
IET Labs, Inc.
IET Labs, Inc.
Keithley
Instruments
Caddock
Electronics
Vishay
HYMEG
Corporation
Refer to the manufacturer's specifications to calculate the uncertainty, which varies for each function
and range test point.
In this manual, the Model 8610 shorting plug is shown in the graphics. However, you can use either
the Model 8610 or Model 8620.
DMM7510-905-01 Rev. A / April 2015
Model Description
5720A or 5730A High Performance
Multifunction Calibrator
5725A Amplifier
8508A 8.5 Digit Reference
Multimeter
33250A Function/Arbitrary
Waveform Generator
1423-A Precision Decade
Capacitor
HACS-Z-A-2E-1uF Series HACS-Z High
Accuracy Decade
Capacitance Box
8610 or 8620 4-Wire DMM Shorting
Plug
200 kΩ, 0.01 %
USF240-200k
tolerance, 2 PPM/ °C
resistor
10 MΩ, 0.25 %
CMF65
tolerance, 50 PPM/ °C
resistor
1 GΩ and 10 GΩ, 2 %
FA-65-1G and FA-
65-10G tolerance, 25 PPM/ °C
resistor
Section 2: Performance verification
Used for: Uncertainty
DCV, ACV, ACI, and See Note.
resistance
DCI and ACI See Note.
DCV and resistance See Note.
Frequency See Note.
Capacitance, 1 nF to See Note.
1 µF
Capacitance, 1 µF to
See Note.
100 µF
DCV, Digitize DCV, and N/A
resistance
10 µA and 100 µA DCI
See Note.
10 µA and 100 µA DCI
See Note.
See Note.
910 MΩ, parallel 1 GΩ
and 10 GΩ
2-3