Rear Wheels - Kubota STW34 Operator's Manual

50 TIRES, WHEELS AND BALLAST
BRear Wheels
Rear tread width can be adjusted as shown with the
standard equipped tires.
To change the tread width
1. Remove the wheel rim and / or disk mounting bolts.
2. Change the position of the rim and / or disk (right and
left) to the desired position, and tighten the bolts.
A Always attach wheels as shown in the drawing.
A If not attached as illustrated, transmission parts may
be damaged.
A When re-fitting or adjusting a wheel, tighten the bolts
to the following torques then recheck after driving the
tractor 200m (200 yards) and 10 times of shuttle
movement by 5 m (5 yards), and thereafter according
to service interval. (See "MAINTENANCE" section.)
A Need to use rear tire spacer when the tread width is
adjusted 990 mm with the 13.6-16 turf tires.
(1) 215 N-m (22 kgf-m)
Tire
Tread
Tire
Tread
To avoid personal injury or death:
A Before jacking up the tractor, park it on a firm
and level ground and chock the front wheels.
A Fix the front axle to keep it from swinging.
A Select a jack that withstands the machine
weight and set it up as shown below.
(1) Jack point
9.5-22 Farm
13.6-16 Turf