Checking Mode - Kubota M5640SU Workshop Manual

M5640SU, M5640DT-SU, WSM
(2) Setting Mode
• Input the various data to RAM.
• There are two different setting modes : "PTO speed display mode switching" and "model select mode".
PTO Speed Display Mode Switching
The PTO speed display mode switching is set at factory. When replacing the instrument panel assembly, enter
the numerical code.
Mode Select Mode
The mode select mode is set at factory. When replacing the instrument panel assembly, enter the model code.

(3) Checking Mode

When Operate PTO Clutch Control Lever
(At hour meter mode)
• Total operating hours are displayed.
• The hour meter indicates in five digits the hours the
tractor has been used; the last digit indicates 1/10 of
an hour.
• When the PTO/Hour meter select switch is pressed
in this state, "OFF" is displayed.
(At PTO speed mode)
• PTO speed are displayed.
• When the PTO/Hour meter select switch is pressed
in this state, the display mode switches to hour meter
mode.
(1) PTO Clutch Control Lever
(2) LCD Monitor
The checking mode checking for sensors, battery
voltage and engine revolution.
The CPU (5) process the input dates from sensors
resistance, taco pulse and voltage to indicate with the
LCD monitor (7).
The check mode shows four items as below.
No. Contents
1 Fuel sensor voltage
Coolant temperature
2
sensor voltage
3 Battery voltage
4 Engine revolution
(1) Engine Speed Sensor
(2) Fuel Sensor
(3) Battery Voltage
(4) Coolant Temperature Sensor
(5) CPU
(6) Buzzer
(7) LCD Monitor
9-M7
ELECTRICAL SYSTEM
A : PTO OFF (Hour Meter
Mode)
B :
(a) ON Position
(b) OFF Position
9Y1210365ELM0010US0
9Y1210365ELM0011US0
Displayed
Condition
unit
F to E V
−30 to 120 °C
V
(−4 to 248 °F)
– V
Idling to max. n/min
a : From Alternator Terminal L
b : From PTO/Hour Meter
Select Switch
c : From Traveling Speed
Select Switch
d : From Main Key Switch
9Y1210365ELM0012US0
KiSC issued 07, 2009 A