Inserting Waypoint - Standard Horizon CP150 Owner's Manual

4.4.1.6 Inserting Waypoint

Every time you place the cursor on the segment connecting two existing Waypoints
of a Route the following functions are available: insert, waypoint, report, delete route.
Place cursor on Route leg
Figure 4.4.1.6 - Placing Waypoint between two existing ones (I)
Press 'ENTER'. Select "INSERT" and press 'ENTER'. The line between the two
Waypoints is turned into a dotted line: move the cursor to the new position. The line
will "rubber-band", drawing a dotted line between the last Waypoint and the cursor,
and another dotted line between the cursor and the next Waypoint:
Figure 4.4.1.6a - Placing Waypoint between two existing ones (II)
Once you have positioned the cursor at new location, press 'ENTER' (press 'CLEAR'
to abort operation):
Figure 4.4.1.6b - Placing Waypoint between two existing ones (III)
GPS Chart 150 Page 41