Inserting A Waypoint Into A Route; Goto A Route; Using [Goto] To Select Route - Standard Horizon CP180 Owner's Manual

7. Move the ShuttlePoint to highlight EDIT ROUTE and press [ENT] or move the
ShuttlePoint knob to the right.
8. Move the ShuttlePoint knob to highlight NAME and press [ENT] or move the ShuttlePoint
knob to the right. A popup window will be shown.
9. Move the ShuttlePoint knob up/down to change the characters and left/right to select a
different character in the Routes Name.
10. When finished press [ENT] to save.
11. Press [CLR] to show the Chart page is shown.
9.5

INSERTING A WAYPOINT INTO A ROUTE

On the CP180/CP180i place the cursor on the navigation line between two Waypoints and
press [ROUTE]. On the CP300/CP300i placing the cursor on the navigation leg between two
points, soft key labels appear: press [I
into a dotted line, see the following picture.
Move the ShuttlePoint knob to the desired location for the new Waypoint: the line will "rubber-
band", drawing a dotted line between the previous Waypoint and the cursor, and another
dotted line between the cursor and the next Waypoint (see the left side of the above picture).
Once you have positioned the cursor at the location you want, press [ENT] (see the right side
of the above picture).
9.6

GOTO A ROUTE

9.6.0

Using [GOTO] to select Route

1. Move the ShuttlePoint knob to an open position (no buoy, warning etc. under the cursor)
on the Chart page.
GPS Chart Plotters
]. The line between the two Waypoints is turned
NSERT
Figure 9.5 - Inserting Waypoint procedure (1)
Figure 9.5a - Inserting Waypoint procedure (2)
Page 69