Headlight Bulb (F/M/Xf); Adjusting Headlight Aim - Arctic Cat Sno Pro 120 Service Manual

7. Loosen the two side headlight assembly screws (A);
then remove the two front headlight assembly screws
(B).
8. Remove the headlight assembly.
INSTALLING
1. With the headlight assembly in position, install the
front headlight assembly screws. Engage the side
headlight screws in the slots and tighten until snug.
2. Engage the side console tabs on the headlight assem-
bly; then place the front of the console over the head-
light assembly7 and press down until it snaps in
place.
3. Install the two screws securing the rear of the con-
sole to the hood. Tighten only until snug.
4. Place the windshield brace assembly into position
and secure to the console with the four screws.
Tighten until snug.
5. Connect the gauge; then connect the electrical acces-
sory wires and the ignition switch.
6. With the windshield in position, secure the wind-
shield to the frame using the four screws. Tighten
securely.
7. Connect the console harness; then install the hood
assembly and secure with the screws.

Headlight Bulb (F/M/XF)

 NOTE: The bulb portion of the headlight is fragile.
PC108
HANDLE WITH CARE. When replacing the headlight
bulb, the bulb assembly must first be removed from
the housing. Do not touch the glass portion of the
bulb. If the glass is touched, it must be cleaned with a
dry cloth before installing.
1. Disconnect the headlight harness connector from the
bulb; then remove the rubber grommet from the
headlight housing.
2. Rotate the bulb retainer counterclockwise until it
unlocks from the housing; then remove the bulb.
PC106A
3. Install the bulb and retainer; then rotate the retainer
clockwise until it properly locks in place.
4. Install the rubber grommet; then connect the head-
light harness connector to the bulb.
5. Check headlight aim (see Adjusting Headlight Aim
PC107A
in this sub-section).
Do not operate the snowmobile unless headlight beam
is adjusted properly. An incorrectly adjusted beam will
not provide the operator the optimum amount of light.

Adjusting Headlight Aim

The headlight can be adjusted for vertical aim of the
HIGH/LOW beam. The geometric center of HIGH beam
zone is to be used for vertical aiming.
1. Position the snowmobile on a level floor so the head-
light is approximately 8 m (25 ft) from an aiming
surface (wall or similar surface).
! WARNING
0746-096
8
8-35