Arctic Cat Sno Pro 120 Service Manual page 85

10. Remove the four Allen-head cap screws securing the
stator plate. Remove the stator plate.
11. Remove the four cap screws securing the seal
retainer plate on the PTO-side; then remove the
plate.
12. Remove the spark plugs.
13. Remove the eight cap screws, two nuts, and two
washers securing the cylinder head to the cylinders;
then remove the cylinder head. Discard the cylinder
head gasket.
MD0255
14. Remove the four 6 mm nuts and eight 10 mm nuts
securing the cylinders to the crankcase.
 NOTE: Using a felt-tip marker, mark the cylinders as
to MAG-side and PTO-side for assembling. Also,
mark the pistons at this time.
MD0078
MD0081
15. Remove the cylinders making sure to support the pis-
tons so they are not damaged. Account for four
dowel pins.
When removing a cylinder, make sure to support the
piston so it will not be damaged.
MD0083
CAUTION
2
MD0289
MD0087
MD0086
2-65