Arctic Cat Sno Pro 120 Service Manual page 23

11. Remove the ground wire from the starter motor; then
remove the two cap screws (A) securing the MAG-
side starter motor bracket to the engine. Remove the
bracket and starter motor and account for the rubber
damper.
12. Remove the two cap screws (B) securing the PTO-
side starter motor bracket to the engine; then remove
the bracket and account for the rubber damper.
 NOTE: At this time, route the starter motor ground
wire out from the engine plate.
13. Remove the cap screw (A) securing the rear MAG-
side engine mounting bracket to the chassis; then
remove the three remaining lock nuts (B) securing
the engine plate to the chassis.
FZ008
14. Move the engine forward enough to remove the cap
screws (C) securing the rear MAG-side engine
mounting bracket to the engine; then remove the
bracket.
Use care when moving the engine forward not to dam-
age the wiring harness.
15. Remove the lock nuts and cap screws (D) securing
the snubber bracket to the chassis; then remove the
bracket.
16. Remove the cap screws and lock nuts securing the
headlight support bracket to the front upper frame;
then remove the bracket and account for the mount-
ing hardware.
17. Loosen the carburetor flange clamps and remove the
carburetors from the intake flanges; then remove the
clamp and disconnect the impulse line from the
FZ024A
crankcase.
FZ023A
After the carburetors have been removed, secure them
in an upright position to avoid fuel running out of the
vent tubes.
18. Disconnect the oil-injection cable from the oil pump
and account for the E-clip and washer; then discon-
nect the oil supply hoses from the pump and plug the
hoses to prevent leakage.
CAUTION
CAUTION
0743-921
2
FZ006
2-3