Arctic Cat Sno Pro 120 Service Manual page 58

22. Install the close-off cover to the front end with the
two cap screws (A) noting the mounting tab (non-
turbo only) (B) is installed with the right-side cap
screw. Tighten cap screws securely.
 NOTE: On the Bearcat Z1 XT, install the close-off
panel; then with the mounting tab (A) on the left front
cap screw, secure the panel with the four cap screws.
23. Place the resonator into position in the chassis and
install the two springs securing the resonator to the
chassis; then install the exhaust pipe and secure to
the manifold and resonator with six springs.
 NOTE: On the non-turbo models, secure the resonator
to the upper frame with the tab washer and hairpin clip.
24. Connect the harness plug-in for the oxygen sensor.
 NOTE: Steps 25-28 are for the turbo model only.
25. Install the upper heat shield; then connect the coolant
return hose to the turbo and secure with the hose clamp.
2-38
 NOTE: To aid in coolant bleeding procedure, do not
secure the upper heat shield to the manifold at this
point.
26. Connect the air bypass hose and the air bypass con-
trol valve hose to the intake pipe and secure with the
clamps.
ZJ020A
27. Install the hose from the waste gate control valve to
the elbow fitting of the turbocharger and secure with
the clamp.
TZ078A
28. Position the intercooler into the grommets of the
mounting bracket; then connect the intercooler hoses
to the turbo and to the intake plenum. Tighten all
hose clamps securely.
29. Connect the harness connector to the ECU.
 NOTE: Before installing the drive clutch, be sure to
wipe both the crankshaft taper and clutch mounting
taper clean using a clean towel.
TZ060A
743-983A
TZ086B
TZ072A