Steering Post (Bearcat/F-Series/T-Series) - Arctic Cat Sno Pro 120 Service Manual

7. Secure the right-side steering boot to the chassis
using five rivets (A).
8. Secure the top of the steering post to the steering
support using the existing machine screws (A) and
new nuts. Tighten to 96 in.-lb.
9. On adjustable steering models, connect the tie rod
(B) from the adjustable steering post to the second-
ary steering post using the machine screw and nut.
Tighten to 20 ft-lb.
10. Install the expansion chamber using the existing
springs; then connect the pipe temperature sensor to
the main harness.
11. Position the hood onto the snowmobile and connect
the hood harness connector.
 NOTE: On the turbo models prior to securing the
hood, make sure the rubber straps of the air filter
housing are accessible.
12. Secure the hood with the six torx-head screws and
tighten securely.
 NOTE: Before installing the hood, make sure the
mounting screw clips are in position.
 NOTE: On the 1100 cc non-turbo models, make sure
the foam seal is in place on the air intake.
 NOTE: On the turbo models, make sure the air filter
housing is properly connected and secured with the
rubber straps to the intake plenum of the hood and
turbocharger.
13. Install the access panel onto the lower console; then
SNO-2219
close the access panel and secure with the hairpin
clip.
Steering Post (Bearcat/F-
Series/T-Series)
REMOVING
1. Open the hood; then remove the two torx-head
screws securing the console to the headlight support
bracket.
SNO-691A
2. Lift the rearward end of the console and disconnect
the main/hood harness connector; then remove the
console.
3. On the standard models, remove the four cap screws,
lock nuts, and adjuster block caps securing the han-
dlebar/riser assembly to the steering post; then lay
the handlebar/riser assembly aside. Account for the
lower adjuster block.
SNO-2226A
4. On the LXR/Sno Pro models, remove the two screws
from the handlebar pad; then remove the self-tapping
screw securing the retainers (A) to the riser block
assembly. Remove the retainer.
0743-777
8
8-5