Spindle (F/M/Xf) - Arctic Cat Sno Pro 120 Service Manual

6. Install the spindle into the spindle housing; then with
the correct number of thrust washers (as noted in
removing) and with the space (A) in the splines of
the spindle aligned with the slot (B) in the steering
arm, install the steering arm.
7. Install the cap screw (threads coated with green Loc-
tite #609) securing the steering arm to the spindle;
then tighten to 40 ft-lb.
8-14
ZJ173B
8. Install the snap ring and spindle cap.
9. Place the steering tie-rod ball joint into position on
the steering arm as noted during removing and
secure with a lock nut. Tighten to 30 ft-lb; then
install the tie rod cap.
ZJ177
10. Install the ski and tighten to 26 ft-lb.
11. Remove the safety stand from beneath the front end.

Spindle (F/M/XF)

REMOVING
1. Position the front of the snowmobile on a safety
stand; then remove the ski (see Ski in this section).
2. Remove the nyloc nut and cap screw securing the
shock absorber to the spindle.
ZJ295A
3. Remove the nyloc nut securing the tie rod to the
spindle arm. Account for the washer on the top side.
ZJ176A
ZJ172
PC087A