Arctic Cat Sno Pro 120 Service Manual page 41

9. Using a small needle-nose pliers, remove the servo-
motor cable holder; then pull the cable housings
down and out of the servomotor.
10. Slide each cable end out of the slot of the pulley;
then disconnect the connector from the servomotor.
11. Remove the lock nuts securing the shock mount
bracket support to the shock mount brackets; then
remove the shock mount bracket support.
12. Drain the engine coolant (see Liquid Cooling System
- Section 3).
13. Loosen the clamp securing the gasline hose to the
throttle body and remove the hose; then close-off the
hose and secure the hose up and out of the way.
The hose may be under pressure; remove it slowly to
PC187A
release the pressure. Place an absorbent towel around
the connection to absorb gas.
14. Loosen the clamps securing the air intake boot to the
throttle bodies and pull the air intake boot forward
enough to gain access to the throttle body assembly.
Remove and retain the clamps.
15. Loosen the flange clamps securing the throttle body
assembly to the intake flanges and disconnect the oil-
injection control rod from the throttle body; then
loosen the clamps securing the throttle body coolant
hoses. Disconnect the TPS and move the throttle
body assembly forward and out of the way.
PC134
16. Remove the main harness wrap and disconnect the
six harness connectors. Secure the harness up and
out of the way.
17. Close-off the oil hose with a clamping device; then
remove the hose clamp and oil hose from the oil pump.
PC186A
! WARNING
PC135A
2
PC138A
PC139A
2-21