Arctic Cat Sno Pro 120 Service Manual page 77

 NOTE: Remove any tape sealing the turbocharger.
CAUTION
Make sure there are no obstructions in the intake and
intercooler side of the turbocharger before installing the
intercooler hose.
31. Install the waste gate control valve hose to the turbo-
charger and install the clamp as noted during remov-
ing; then install the side cover and secure with the
screws.
PC055A
32. Install the exhaust resonator to the chassis support
and secure with the spring; then secure the resonator
to the exhaust pipe and tighten the cap screws and
flange nuts to 12 ft-lb.
 NOTE: Steps 33-34 are for the non-turbo models
only.
33. Position the exhaust pipes and resonator into the
chassis and install and secure the MAG and PTO
exhaust flanges (with new gaskets) to the cylinder
head with the flange nuts. Tighten evenly to 17 ft-lb.
34. With the resonator properly installed to the chassis
support, install the spring securing the resonator to
PC054A
the mounting tab.
 NOTE: With the exhaust system installed, connect
the oxygen sensor to the harness connector.
Non-Turbo
PC053A
PC052A
2
PC024A
PC241A
2-57