Arctic Cat Sno Pro 120 Service Manual page 299

CAUTION
Care must be taken not to damage the driven pulley shaft.
 NOTE: Once the roller pin is exposed, it may be nec-
essary to use a pair of vise-grips to remove the pin.
3. Place the new roller into position and tap the roller
pin in far enough to install the spring pin.
4. Tap the spring pin back into place.
CM065
ASSEMBLING
1. Place the torque bracket onto the Driven Pulley
Compressor Tool; then install the spring seats onto
the torque bracket and place the spring into position.
FS105
CM066
 NOTE: Premature wear will result if the plastic
washer is not installed.
2. Noting the alignment marks made during disassem-
bling and with the spring seat and spacer on the sta-
tionary sheave shaft, place the stationary sheave onto
the torque bracket.
CM067A
CM068A
6
CM064
CM063
6-7