Arctic Cat Sno Pro 120 Service Manual page 70

Non-Turbo
Turbo
 NOTE: Before removing the mounting hardware
securing the engine to the chassis, remove the
weight of the engine from the chassis using a suit-
able lift or hoist.
33. On the turbo models, remove the front bumper.
34. Remove the front belly pan cap screws; then remove
the belly pan. Remove the cap screws securing the
access panel to the chassis; then remove the access
panel.
35. Remove the two lock nuts securing the front engine
mount to the chassis.
36. Remove the cap screws securing the MAG-side rear
engine to chassis mount; then remove the mount.
37. Remove the screw securing the front belt guard to
the skid plate, then remove the cap screws, lock nuts,
and carriage bolt securing the PTO-side chassis sup-
port. With the fuse block out of the bracket, remove
the support with the front belt guard.
2-50
 NOTE: After removing the PTO-side chassis sup-
port, re-install the cap screw securing the rear PTO-
side engine to chassis mount (bearing bracket) to
secure the bearing.
0746-313
38. Remove the cap screws securing the PTO-side
engine to chassis mount (bearing bracket).
39. Disconnect the harness connectors from the regula-
tor/rectifier and magneto; then remove the cap
screws securing the routing clamp to the engine
(non-turbo models) and secure the wire harness up
and out of the way.
0746-314
Non-Turbo
Turbo
40. Raise the engine up and tip the engine forward
enough to remove the cables from the starter motor
and the rear engine/heat exchanger coolant hose.
PC060A
PC209A
PC037A
PC206A