Handlebar Height/Tilt (M/Xf); Handlebar Tilt (Zr/Xf) - Arctic Cat ZR 5000 2015 Operator's Manual

Code
P0201 Injector circuit/open - cylinder 1
P0202 Injector circuit/open - cylinder 2
P0203 Injector circuit/open - cylinder 3
P0217 Engine coolant over temp condition
P0261 Cylinder 1 injector circuit low
P0264 Cylinder 2 injector circuit low
P0267 Cylinder 3 injector circuit low
P0508 Idle air control system circuit low
P0509 Idle air control system circuit high
P0511 Idle air control circuit
P0522 Engine oil pressure sensor circuit low
P0523 Engine oil pressure sensor circuit high
P0562 System voltage low
P0563 System voltage high
P0780 Shift Error
P1315 Crankshaft Position out of sync
P1338 Crankshaft spike detected
P1339 Crankshaft tooth not detected
P1685 Main relay open circuit
P1686 Main relay circuit low
P1688 Reverse relay open circuit
P1689 Reverse relay circuit low
P1691 Forward relay open circuit
P1692 Forward relay circuit low
P1694 Headlight relay open circuit
P1695 Headlight relay circuit low
P2228 Barometric pressure sensor A circuit
low
P2229 Barometric pressure sensor A circuit
high
P2300 Ignition coil A primary control circuit
low
P2303 Ignition coil B primary control circuit
low
P2306 Ignition coil C primary control circuit
low
U1000 Vehicle not registered or invalid PIN
U1001 Vehicle not registered and vehicle lim-
its enabled
U0155 Lost communication with the ECM
Handlebar Height/Tilt
(M/XF)
To adjust handlebar height, use the fol-
lowing procedure:
1. From each side of the steering post,
compress the locking tabs to unlock
the handlebar.
Trouble
2. With the tabs compressed, adjust the
handlebar up or down to the desired
position; then release the tabs to lock
the handlebar in place.

NOTE: When the desired height is
found, make sure that the lock collar
is seated in the grooves by lifting up
and pressing down on the handlebar.
To adjust handlebar tilt, use the following
procedure:
1. Loosen the four cap screws and tilt
the handlebar to the desired position.
2. Tighten the four cap screws evenly
to 15 ft-lb.
! WARNING
Tighten the cap screws according to
specifications to prevent unexpected
"movement" of the handlebar during
operation over rough terrain. DO NOT
position handlebar so steering (maxi-
mum right/left turning capabilities) or
throttle and brake controls are affected.

Handlebar Tilt (ZR/XF)

The handlebar can be adjusted to the
operator's preference. To adjust the han-
dlebar, use the following procedure:
1. Remove the handlebar cover; then
loosen the eight cap screws securing
the handlebar caps to the riser and the
riser to the steering post.
0747-618
0747-617
13