Arctic Cat Sno Pro 120 Service Manual page 57

15. Install the four remaining cap screws securing the
upper frame/support gusset to the steering support.
16. Install the coolant/separator tank assembly and
secure to the right-side upper frame with cap screw
and two lock nuts. Tighten securely; then install the
hoses to the proper locations on the tank assembly
and water pump as noted during removing. Secure
with clamps.
 NOTE: At this time, make sure the coolant hoses
from the coolant tank to the throttle body assemblies
and throttle bodies to the left-side cylinder head are
secured and properly routed. On the turbo model,
make sure the throttle body coolant return hose is
secured.
743-995A
17. Connect the harness plug-ins to the ignition coils (A)
and camshaft sensor (B); then route the main harness
to the proper connector locations and secure with
cable ties as noted during removing.
Make sure the harness is routed away from the exhaust
or any moving parts.
TZ081A
18. On the turbo model, install the spark plug wires and
the throttle cable to the throttle body pulley and
bracket; then tighten the jam nuts securely.
19. On the non-turbo models, install the air silencer (see
Section 3); then on all models, install the gas tank
(see Section 8).
20. Connect the fuel pump four-wire connectors (A);
then connect the harness plug-in (B) to the regulator/
rectifier.
ZJ018B
21. With the harness connected, install the air pressure
sensor to the bracket on the right-side upper frame.
CAUTION
TZ075A
2
ZJ094A
ZJ011C
2-37