Drive Train (F/M/Xf 1100) - Arctic Cat Sno Pro 120 Service Manual

 NOTE: If no tabs align with the slots, tighten until
one aligns; then bend tab to lock nut.
12. Secure the lower/upper sprocket with the chain to the
driveshaft with the retaining ring and the upper
sprocket to the driven shaft with a spring washer and
cap screw (coated with blue Loctite #243). Tighten
to 25 ft-lb.
 NOTE: Make sure washer is cupped toward the
sprocket.
13. Install the chain tensioner assembly and ratchet
block.
PC247A
14. Install the chain case cover/oil tank assembly and
secure with the self-tapping screws. Tighten in a
crisscross pattern to 105 in.-lb.
 NOTE: If a new case is being installed, tighten to
144 in.-lb.
15. Fill the chain case with 12 oz of Arctic Cat Trans-
mission Lube (p/n 4639-364).
16. Connect the speed sensor connector.
17. Install the right-side footrest support and secure to
the belly pan using the torx-head screw.
18. Install the right-side footrest; then install the resonator.
19. Secure the lower console to the skid panels; then
install the hood and side panels.

Drive Train (F/M/XF 1100)

REMOVING CHAIN CASE/DRIVEN
SHAFT/DRIVESHAFT/TRACK
1. Remove the left- and right-side panels, hood, then
PC249A loosen the retaining pins securing the lower console
to the skid panels and secure out of the way.
2. Remove and discard the exhaust gaskets, cap screws,
and nuts securing the resonator; then remove the res-
onator.
3. Remove the right-side footrest; then remove the torx-
head screw securing the belly pan to the right-side
footrest support.
PC250A
PC248A
6
SNO-753A
6-29