Arctic Cat Sno Pro 120 Service Manual page 67

17. Remove the cap screws (E) and (H) securing the side
supports; then remove the supports noting the posi-
tion of the cable ties and harnesses.
 NOTE: On the non-turbo models before removing
the MAG-side support, the MAP sensor must be
removed and the cable ties securing the wire harness
and vent hose must be removed.
18. Remove the cap screws and nuts securing the front
spars to the steering support; then remove the torx-
head screws securing the steering post bracket to the
steering support. Remove the steering support.
PC057A
19. Remove the cap screws (F) or (G) securing the shock
mounting bracket support to the shock mounting
brackets; then remove the cap screws (C) securing
the lower front spars to the shock mounting brackets.
Remove the shock mounting bracket support and
front spars accounting for the spar inserts.
 NOTE: On the turbo models, the shock mounting
bracket support, left front spar, and heat shield are
removed as an assembly.
PC058A
20. Remove the MAG-side chassis support. Account for
and note the location and orientation of the resonator
spring tab and resonator support bracket.
746-292C
21. Clamp off the coolant bypass hose and remove the
hose from the water pump; then add a length of hose to
the bypass hose and route the hose out of the exhaust
opening of the skid plate. Drain the remaining coolant.
PC029A
PC030
2
PC210A
PC026A
2-47