Sway Bar (F/Xf); Sway Bar (F-Series/T-Series); Series) - Arctic Cat Sno Pro 120 Service Manual

3. Install the bushings, sleeves, and spacers into each
shock end; then place the shock absorber into posi-
tion and secure with the cap screws and lock nuts.
Tighten the lock nuts to 20 ft-lb (Bearcat/F-Series/T-
Series) or 32 ft-lb (F/M/XF).

Sway Bar (F/XF)

REMOVING
1. Remove the nyloc nuts and cap screws securing the
sway bar link to the lower A-arm and the sway bar.
2. Remove the torx-head screws securing the sway bar
mounting brackets; then pull the sway bar out of the
snowmobile.
INSPECTING
1. Inspect the sway bar for any signs of twisting,
fatigue, or wear.
2. Inspect the sway bar arms for cracks or damage.
3. Inspect the links, bushings, bushing retainers, and
hardware for damage or wear.
INSTALLING
1. Place the sway bar into the sway bar mounting
brackets; then install the sway bar into the snowmo-
bile. Secure with the torx-head screws and tighten to
96 in.-lb.
2. Secure the sway bar links to the sway bar and lower A-
arm with the cap screws and new nyloc nuts. Tighten to
23 ft-lb.
8-24
Sway Bar (F-Series/T-
REMOVING
1. Remove the two lock nuts securing the sway bar
mounting brackets to the chassis; then using a soft
hammer, tap the sway bar in either direction until the
sway bar link is off the pin on the A-arm.
2. Slide the sway bar out of the chassis and account for
the sway bar links and four sleeves.
PC093A
INSPECTING
1. Inspect the sway bar for any signs of twisting,
fatigue, or wear.
2. Inspect the sway bar links for cracks or damage.
INSTALLING
1. Place the sway bar into position in the chassis; then
install the sway bar links to each end of the sway bar
and position the links onto the pins of the A-arms.
2. With the sway bar properly positioned in the chassis,
install the sleeves onto the sway bar. Install the sway
bar mounting brackets and secure the brackets with
the lock nuts. Tighten to 120 in.-lb.
Front Suspension
Mounting Bracket
(Bearcat/F-Series/T-Series)
 NOTE: On the F5 LXR to remove the front suspension
mounting bracket, it will be necessary to remove the air
silencer. Proceed to Air Silencer (F5 LXR) sub-section
in Section 3 and follow REMOVING procedure.
REMOVING
1. Elevate the front of the snowmobile with a suitable
safety stand or lift.
 NOTE: Steps 2-5 are for the 1100 cc models only.
2. Remove the hood; then remove the self-tapping
screws securing the front bumper assembly to the
PC093A
left-side and right-side panels.

Series)

0744-929