Driven Pulley (F/M/Xf) - Arctic Cat Sno Pro 120 Service Manual

Driven Pulley (F/M/XF)

REMOVING
1. With the engine off, remove the drive belt (see Drive
Belt in this section).
2. Slide the driven pulley off the shaft.
 NOTE: Account for in any alignment washers.
These washers must be in place during installation.
DISASSEMBLING
1. Place the driven pulley on the Driven Pulley Com-
pressor Tool; then install the compressor flange
spacer and wing nut and compress the driven pulley
spring.
2. Remove the torx-head screws (A) securing the back-
side cams; then remove the cap screws (B) securing
the movable sheave to the torque bracket.
 NOTE: To loosen the cap screws, it may be neces-
sary to heat the heads with a torch to soften the Loc-
tite.
3. Release the compression of the spring by removing
the wing nut; then remove the movable sheave.
4. Remove the stationary sheave; then remove the plas-
tic spring seat.
5. Remove the spring and remaining spring seat.
PC109
PC110A
PC127
PC111
6
PC112
PC113
6-9