Arctic Cat Sno Pro 120 Service Manual page 318

14. With the socket on the ring nut, lightly tap the socket
to disengage the adapter sleeve.
15. Remove the inner retaining ring; then from the left
side carefully remove the driven shaft assembly
keeping the bearing 90° to the shaft.
16. Remove the skid frame assembly (see Section 7).
17. Remove the brake shield and the left-side footrest.
 NOTE: DO NOT split the brake caliper unless neces-
sary service work is required.
18. Remove the cap screws securing the inner caliper to
the tunnel; then remove the inner caliper.
6-26
PC251A
19. Pull the driveshaft out to the left; then drop out of
tunnel right side first.
PC164
 NOTE: If the caliper does not remove from the drive-
shaft easily, proceed to step 20.
20. Remove the brake pads; then remove the outer brake
caliper. Account for a rubber seal.
 NOTE: Place an absorbent towel under the caliper
to absorb slight amount of brake fluid. Do not com-
press the brake lever.
PC165A
21. Remove the retaining ring securing the brake disc to
the driveshaft and remove the brake disc.
PC148A
PC14
PC172