Arctic Cat Sno Pro 120 Service Manual page 402

12. Remove the cap screws from the rear arm limiter
(A); then remove the cap screw and flat washer
securing the rear idler wheel. Remove the idler
wheel; then remove the adjuster bushing.
 NOTE: The adjusting bolt may have to be loosened
to remove the adjuster bushing.
13. Remove the cap screw securing the rear arm coupler
block to the slide rail. Account for the block, bush-
ing, cap screw, and lock nut.
7-52
TZ042A
14. Remove the lock nut from the cap screw securing the
rear arm assembly to the slide rail.
 NOTE: If removing the cap screw is necessary to
TZ044B
replace the slide rail, install the cap screw from the
opposite side into the assembly to secure the compo-
nents and aid in replacing the slide rail.
15. Remove the torx-head cap screws and lock nuts
securing the track adjuster bracket.
TZ045
 NOTE: At this point, the slide rail should be free of
the skid frame components and can be removed.
TZ046A
TZ046B
TZ048A