Arctic Cat Sno Pro 120 Service Manual page 74

CAUTION
Make sure the harness is routed away from the exhaust
or any moving parts.
17. Install and secure air silencer and clamps to the throt-
tle bodies; then connect the air temperature sensor to
the air silencer.
 NOTE: Steps 18-22 are for the turbo models only.
18. Install the flanges to the manifold adapter assembly
and secure with the clamps; then install the manifold
and throttle body assembly and secure with the two
upper clamps.
 NOTE: Remove any tape sealing the intakes.
19. Install and secure the throttle body coolant hoses to
the coolant tank and cylinder head.
2-54
ZJ094A
20. With the spark plug wires routed properly, install the
spark plug caps to the spark plugs.
 NOTE: Make sure the caps are firmly seated on the
plugs.
21. Install and secure the throttle cable to the bracket and
pulley noting the routing of the cable; then connect
the idle speed control.
PC033A
PC046A
22. With the wire harness properly routed, install the
harness connectors to the throttle position sensor, air
temperature sensor, boost sensor, and cam position
sensor.
PC211A
SNO-741A
0743-992