Testing Headlight Switch; Testing Key Switch - Arctic Cat 2018 ZR 200 Service Manual

3. With the handwarmer toggle in the ON position, con-
nect one ohmmeter lead to pin and the other ohmme-
ter lead to pin. The meter must read 1 ohm or less
resistance.
ONS-017
4. Connect the green/white wire to the bottom terminal
and the brown wire to the top terminal on the switch.
Close and latch the hood.

Testing Headlight Switch

1. Open the hood; then disconnect the main harness
wires from the switch.
2. With the headlight toggle in the HIGH BEAM posi-
tion, connect one ohmmeter lead to pin and the other
ohmmeter lead to pin. The meter must read 1 ohm or
less resistance.
ONS-042
38
3. With the headlight toggle in the LOW BEAM posi-
tion, connect one ohmmeter lead to pin and the other
ohmmeter lead to pin. The meter must read 1 ohm or
less resistance.
ONS-043
4. Connect the white wire to the bottom terminal (LOW
BEAM), the yellow wire to the middle terminal and
the blue wire to the top terminal (HIGH BEAM) on
the switch. Close and latch the hood.

Testing Key Switch

1. Open the hood; then disconnect the main harness
wires from the key switch.
2. With the key in the OFF position, connect one ohm-
meter lead to pin and the other ohmmeter lead to pin.
The meter must read 1 ohm or less resistance.
3. With the key in the ON position, connect one ohm-
meter lead to pin and the other ohmmeter lead to pin.
The meter must read more than 10,000 ohms.