Arctic Cat Sno Pro 120 Service Manual page 76

F. Shock mounting bracket support to shock mount-
ing brackets (non-turbo) = 2 cap screws, inserts,
and 2 lock nuts. Tighten to 20 ft-lb.
 NOTE: On the turbo models, secure the front heat
shield to the chassis with the screws.
 NOTE: On the non-turbo models, install the MAP
sensor to the bracket on the MAG-side steering sup-
port.
26. With the throttle cable in place, install and secure the
steering post to the steering bracket with the mount-
ing blocks, cap screws, and lock nuts. Tighten to 96
in.-lb.
27. Install and secure the handlebar to the steering post
with the caps and four cap screws. Tighten the cap
screws to 15 ft-lb.
 NOTE: Connect the handlebar harness to the main
harness connector and secure the connectors to the
harness at the PTO-side steering support.
2-56
28. Install the throttle cable into the lever; then verify the
throttle lever free-play is within specification.
PC058A
 NOTE: Steps 29-32 are for the turbo models only.
29. Install the fascia and install the front pins (B) of the
intercooler into the brackets; then install the rear
brackets (A) to the pins of the intercooler and secure
the brackets to the chassis with cap screws and lock
nuts. Tighten securely.
PC029A
30. Install and secure the turbocharger/intercooler hose
and air intake hose; then secure the intercooler hose
to the throttle body.
PC030
PC061A
0741-518A
PC056A