Arctic Cat Sno Pro 120 Service Manual page 311

7. Using a suitable bearing press and fixture, press the
input shaft bearing out of the gear case cover.
Account for a bearing and a seal.
8. Secure the gear case in a suitable clamping device;
then using the procedure from step 5, remove the
outer bearing from the transfer gear.
CAUTION
If any transfer gear bearings are removed, always
replace them with new ones or severe component
damage may occur.
9. Place the gear case on its side; then using a soft ham-
mer, tap the output shaft until the slider and output
gear assembly come free of the gear case.
10. Remove the output gear assembly from the slider
housing.
ZJ191
MS331
11. Using a suitable bearing puller, remove the inner
bearing from the transfer gear assembly. Account for
a spacer washer.
ZJ192
12. Remove the transfer gear from the planetary gear
assembly and account for the thrust washer and
thrust bearing.
ZJ193
ZJ194
6
ZJ195
6-19