Backrest/Rack Assembly (Bearcat); Rear Bumper/Snowflap (Bearcat/F-Series/T-Series) - Arctic Cat Sno Pro 120 Service Manual

2. Connect the taillight harness connector; then secure
the taillight to the taillight support with the two torx-
head screws. Tighten to 48 in.-lb.
BEARCAT 570/T-SERIES
1. Remove the torx-head cap screws securing the tail-
light access panel.
2. Disconnect the harness connector and remove housing.
3. Push in on the socket and rotate it counterclockwise
to remove it from the housing.
4. Remove the old bulb by pulling it straight out of the
socket.
5. Install the new bulb in the socket by pushing it
straight in.
6. Push the socket into the housing and rotate it clock-
wise to lock into place.
7. Connect the harness connector.
8. Secure the access panel with the torx-head cap screws.
Backrest/Rack Assembly
(Bearcat)
REMOVING
1. Remove the cap screws, washers, and cap nuts secur-
ing the rack to the backrest.
2. In turn on each side, remove the two cap screws
(inside the tunnel) securing the backrest assembly to
the tunnel. Account for the washers.
3. If applicable, disconnect the passenger handwarmer
wiring harness.
4. Remove the backrest assembly from the tunnel.
Account for the two spacers.
INSTALLING
1. Place the backrest assembly and spacers (located on
the rear hole on each side) into position and align
holes with tunnel mounting holes.
2. Install the cap screws with washers from the inside
of the tunnel and secure with the washers and lock
nuts. Tighten securely.
PC102A
3. In turn on each side, install the 1/4-in. cap screw in
the front hole and the 5/16-in. cap screw in the rear
hole. Secure with a flat washer and lock nut. Tighten
securely.
4. If applicable, connect the passenger handwarmer
wiring harness.
5. Place the rack into position and secure with the cap
screws, washers, and cap nuts.
Rear Bumper/Snowflap
(Bearcat/F-Series/T-Series)
REMOVING BUMPER/SNOWFLAP
(Bearcat XT)
 NOTE: The snowflap can be removed without
removing the bumper by removing the four torx-head
cap screws and lock nuts.
1. Remove the four torx-head cap screws and lock nuts
742-467A
securing the bumper assembly to the running board;
then remove the four lock nuts from under the tun-
nel. Account for the U-nuts and cap screws.
2. Slide the bumper off the tunnel.
3. Remove the four torx-head cap screws securing the
snowflap to the tunnel. Account for cap screws,
washers, and lock nuts.
INSTALLING BUMPER/SNOWFLAP
(Bearcat XT)
1. Secure the snowflap to the tunnel with the cap
screws, washers, and lock nuts taking care to place
the washers next to the underside of the snowflap.
Finger-tighten the cap screws to the lock nuts; then
tighten the cap screws to 20 ft-lb.
2. Place the bumper assembly into position on the tun-
nel and secure to the running boards with the torx-
head cap screws; then from under the tunnel, install
the four lock nuts and tighten to 20 ft-lb.
REMOVING BUMPER SNOWFLAP
(Bearcat 570/T-Series)
1. Remove the four torx-head cap screws, lock nuts,
and washers securing the snowflap to the tunnel.
8
8-31