Arctic Cat Sno Pro 120 Service Manual page 394

Rear Arm/Rear Shock
Pivot Assembly
REMOVING
1. With the skid frame removed using the Rear Suspension
Spring Tool, remove the spring from the adjusting cam.
! WARNING
Care must be taken when removing the spring or dam-
age or injury could result.
2. Mark the offset arm and the idler arm for assembly
purposes.
3. Loosen the cap screws and lock nuts securing the
offset arm assembly to the idler arm; then remove the
offset arm assembly. Account for a flanged axle,
idler spacer, and washer.
7-44
4. Remove the idler wheel.
 NOTE: Use the Idler Wheel Puller Kit to remove the
wheel.
TZ002A
5. Remove the cap screw, flat washers, and lock nut
securing the spring slide and overload spring to the
slide rail. Account for the spring slide and all mount-
ing hardware.
TZ003
 NOTE: If the overload spring is being removed, use
a punch to drive the bushing out from the back side
of the slide rail and remove the spring.
TZ004A
FZ036
TZ005
TZ007A