Mitsubishi Electric FX3G SERIES Programming Manual page 848

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
Number and name
High-Speed Counter Comparison, High-Speed Table, and Positioning [Positioning is supported in FX
HSZ (FNC 55) instruction:
[D]8130
High-speed comparison table counter
HSZ (FNC 55) and PLSY (FNC 57) instructions: Speed
[D]8131
pattern table counter
[D]8132 Lower HSZ (FNC 55) and PLSY (FNC 57) instructions:
[D]8133 Upper
[D]8134 Lower HSZ (FNC 55) and PLSY (FNC 57) instructions:
[D]8135 Upper
D 8136 Lower PLSY (FNC 57), PLSR (FNC 59) instructions:
D 8137 Upper
[D]8138 HSCT (FNC280) instruction: Table counter
HSCS (FNC 53), HSCR (FNC 54), HSZ (FNC 55), and
[D]8139 HSCT (FNC280) instructions:
Number of instructions being executed
Lower Accumulated number of pulses output to Y000 for
D 8140
D 8141 Upper
Lower Accumulated number of pulses output to Y001 for
D 8142
D 8143 Upper
[D]8144 Not used
ZRN (FNC156), DRVI (FNC158), and DRVA (FNC159)
instructions:
D 8145
Bias speed
Default: 0
D 8146 Lower
D 8147 Upper
ZRN (FNC156), DRVI (FNC158), and DRVA (FNC159)
instructions:
D 8148
Acceleration/deceleration time
Default: 100
[D]8149 Not used
*1. Must be changed to 10000 or less by PLC program.
846
Content of register
Speed pattern frequency
Number of target pulses for speed pattern
Accumulated total number of pulses output to
Y000 and Y001
PLSY (FNC 57) and PLSR (FNC 59) instructions,
or current address of Y000 for positioning
instruction
PLSY (FNC 57) and PLSR (FNC 59) instructions,
or current address of Y001 for positioning
instruction
ZRN (FNC156), DRVI (FNC158), and DRVA
(FNC159) instructions:
Maximum speed
• Default in FX and FX : 100000
1S 1N
*1
• Default in FX : 100000
1NC
37 Operation of Special Devices (M8000 -, D8000 -)
37.1 Special Device List (M8000 -, D8000 -)
Applicable model
Correspond-
FX FX FX ing special
3G 3U 3UC
device
, FX
3G 1S
– M8130
– M8132
– M8132
– M8132
–
– M8138
– M8139
–
–
– – – –
– – – –
– – – –
– – – –
– – – –
FX FX FX FX FX
1S 1N 2N 1NC 2NC
, FX , and FX PLCs.]
1N 1NC
– – –
– – –
– – –
– – –
– – – – –
– – – – –
– – – – –
– –
*1
– –
– –
– – – – –