Appendix A-1-4 Cautions On Using Transparent Function By Way Of Usb In Got1000 Series - Mitsubishi Electric FX3G SERIES Programming Manual

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
Appendix A-1-4 Cautions on using transparent function by way of USB in GOT1000 Series
Make sure to provide the following setting when monitoring circuits, monitoring device registration and reading/writing
programs in an FX
the USB in the GOT1000 Series.
If the following setting is not provided, a communication error occurs.
When using transparent function by way of USB in
GOT1000 Series
When using transparent function by way of RS-232 in
GOT1000 Series
When directly connecting GX Developer to PLC
When directly connecting GX Developer to PLC
(standard built-in RS-422 port)
Setting in GX Developer (Ver. 8.22Y or later)
1. Select [Online] → [Transfer setup...] to open "Transfer setup" dialog box.
2. Double-click [Serial] in [PC side I/F] to open "PC side I/F Serial setting" dialog box.
3. Select "USB (GOT Transparent mode)".
FX PLC
3G
FX /FX PLC
3U 3CU
4. Click [OK] button to finish the setting.
900
/FX /FX PLC using GX Developer Ver. 8.22Y or later and the transparent function by way of
3G 3U 3UC
Double-click it.
Double-click it.
A Programming Tool Applicability and Version Upgrade History
GX Developer Ver.8.21X or former
Not supported (not available)
Set "COM port" and "Transmission
speed" on "PC side I/F Serial setting"
dialog box.
Select "USB (GOT transparent mode)"
This example shows a window displayed
when GX Developer Ver. 8.72A is used.
Select "USB (GOT transparent mode)"
This example shows a window displayed
when GX Developer Ver. 8.72A is used.
A-1 Programming Tool Applicability
GX Developer Ver8.22Y or later
Setting shown below is required.
Select "RS-232C" in setting shown
below, and set "COM port" and
"Transmission speed".