Mitsubishi Electric FX3G SERIES Programming Manual page 41

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
b) FX PLCs
3G
Contact image
memory
(X, Y, M, S)
Timer contact
Time counting coil
(T)
Counter contact
Counting coil
Reset coil (C)
*1. These registers can be changed from the general type to the latched (battery backed) type by the parameter
setting when the optional battery is installed.
*2. Some devices are cleared when the PLC status switches from STOP to RUN.
Item
Input relay (X)
Output relay (Y)
General type auxiliary relay (M)
Latched (EEPROM backed) type
auxiliary relay (M)
Special type auxiliary
relay (M)
General type state relay (S)
Latched (EEPROM backed) type
state relay (S)
Annunciator (S)
For 100 ms
For 10 ms
For 1 ms
Retentive type for
100 ms
Retentive type for 1 ms
General type
Latched (EEPROM backed) type
High-speed type
2 Overview (Sequence Program)
2.6 Program Memory and Devices
Power
Power OFF
OFF→ON
Cleared.
Cleared.
*1
Cleared.
Does not change.
Set to initial val-
Cleared.
*2
ues.
*1
Cleared.
Does not change.
Does not change.
Cleared.
Cleared.
Cleared.
Does not change.
Does not change.
Cleared.
Cleared.
Cleared.
→ For special data registers, refer to Chapter 37.
STOP→RUN RUN→STOP
Does not
Cleared.
change.
Does not change while M8033 is
ON.
Does not
Cleared.
change.
Does not change while M8033 is
ON.
Does not
Cleared.
change.
Does not change while M8033 is
ON.
*2
Does not change.
Does not change.
Does not
Cleared.
change.
Does not change while M8033 is
ON.
Does not
Cleared.
change.
Does not change while M8033 is
ON.
Does not
Cleared.
change.
Does not change while M8033 is
ON.
Does not
Cleared.
change.
Does not change while M8033 is
ON.
Does not
Cleared.
change.
Does not change while M8033 is
ON.
Does not
Cleared.
change.
Does not change while M8033 is
ON.
39
1
2
3
4
5
6
7
8
9
10