Mitsubishi Electric FX3G SERIES Programming Manual page 63

FX /FX /FX Series Programmable Controllers
3G 3U 3UC
Programming Manual - Basic & Applied Instruction Edition
7
Setting the PLC system (2)
1. Click "PLC system (2)" tab.
2. Only when a latch (battery backed) area for a serial port exists through an extended PLC, select
a channel to be set and put a check mark next to "Operate communication setting."
When not performing the communication setting for a serial port, do not put a check mark next
to "Operate communication setting."
Channel selection
Set item
Channel selection
Operate communication setting
Protocol
Data length
Parity
Stop bit
Transmission speed
Header
Terminator
Control line
H/W type
Control mode
Sum check
Transmission control procedure
Station number setting
Time out judge time
Contents of setting
Select a channel in which a serial port is set.
Check mark this box when using the selected serial port in "computer link", "non-
protocol communication" or "inverter communication".
Do not put a check mark when transferring and monitoring sequence programs
in GX Developer or when using the selected serial port in simple N : N link or
parallel link.
Set each item in accordance with application.
→ For details on each item, refer to the Data Communication Edition manual.
2 Overview (Sequence Program)
2.7 Types and Setting of Parameters
This example shows a window in
an FX /FX PLC.
3U 3UC
Setting range
CH1,CH2
–
1
2
3
4
5
6
7
8
9
10
61