Install The Battery; Replacing The Scc Module; Remove The Scc Module - Oracle Sun Netra T5440 Service Manual

Install the Battery

Install the Battery
Before You Begin
Note -
1. Remove the replacement battery from its packaging.
2. Carefully press the new battery in the slot
See Chapter 6, "Returning the Server to Operation"
3.
online.
4.11

Replacing the SCC Module

This section describes how to remove install the system SCC module on the motherboard.
Note -
Caution -
Caution -
variable settings for ILOM. If you are replacing a motherboard, you must move the SCC
module from the old motherboard to the new one.

Remove the SCC Module

Back up OpenBoot PROM variables with one of the following procedures:
1.
For ILOM 3.0 Web Interface: Back up per Chapter 10, "Backing Up and Restoring ILOM
■
Configuration," from the Oracle Integrated Lights Out Manager (ILOM) 3.0 Web Interface
Procedure Guide (820-0052) available at:
index.html. Use a passphrase to backup the OpenBoot PROM variables.
For ILOM 3.0 CLI: Back up per Chapter 10, "Backing Up and Restoring ILOM
■
Configuration," from the Oracle Integrated Lights Out Manager (ILOM) 3.0 CLI Procedure
Guide (821-1611) available at: http://docs.oracle.com/cd/E19860-01/index.html. Use
a passphrase to backup the OpenBoot PROM variables.
For ILOM 2.0: The ILOM Back up/Restore feature is absent. Record output from the
■
OpenBoot PROM printenv command or the Oracle Solaris eeprom command for use after
motherboard replacement.
112 Sun Netra T5440 Server • September 2015
The battery is a CR-1225 or equivalent.
The SCC module is also known as the IDPROM chip.
This procedure must be performed by a certified Sun Oracle Service Technician only.
The SCC module contains system host ID, MAC addresses, and configuration
(Figure 4-23).
to bring the server back
http://docs.oracle.com/cd/E19860-01/