Table of Contents
Advertisement
2.
Perform the following tasks to prepare the server for disk backplane assembly
removal:
"Power Off the Server" on page 59
■
■
"Disconnect Cables From the Server" on page 60
■
"Remove the Server From the Rack" on page 60
"Perform Antistatic Measures" on page 61
■
"Remove the Top Cover" on page 62
■
■
"Remove the PCI Mezzanine Assembly" on page 86
■
"Remove the Memory Mezzanine Assembly" on page 98
"Remove the System Fan Assembly (Fan Tray 0)" on page 135
■
"Remove the SCC Module" on page 112
■
■
"Remove the Motherboard Assembly" on page 114
"Remove the SAS Expander Assembly" on page 125
■
"Remove the Hard Drive Fan Assembly (Fan Tray 1)" on page 138
■
Remove all of the hard drives.
3.
Note their positions before removing. See
4.
Remove the two bus bars that secure the disk backplane in place.
5.
Remove the ribbon cables from the disk backplane.
6.
Loosen the three green captive screws securing the disk backplane.
7.
Slide the disk backplane upward to remove it from the chassis.
8.
Place the disk backplane on an antistatic mat.
Remove the Disk Backplane Assembly
"Install a Hard Drive" on page
Chapter 4 • Replacing Motherboard Assembly Components
66.
123
Advertisement
Table of Contents
