Replacing Pcie/Xaui Cards 4-6 And Pcie Cards 7-9; Remove Pcie/Xaui Cards 4-6 And Pcie Cards 7-9 - Oracle Sun Netra T5440 Service Manual

4.3 Replacing PCIe/XAUI Cards 4-6 and PCIe Cards 7-9
4.3

Replacing PCIe/XAUI Cards 4-6 and PCIe Cards 7-9

For additional installation information and configuration details, refer to the documentation that
shipped with your PCI card.
Caution -
4 only. If you are installing this HBA, see
HBA, Internal" on page 81
Note -

Remove PCIe/XAUI Cards 4-6 and PCIe Cards 7-9

1. Prepare the server for PCIe card removal. See:
"Power Off the Server" on page 59
■
"Disconnect Cables From the Server" on page 60
■
■ "Remove the Server From the Rack" on page 60
■ "Perform Antistatic Measures" on page 61
"Remove the Top Cover" on page 62
■
Pull the release tab out
2.
Carefull pull the card straight up and out
3.
Place it on an antistatic mat.
4. If you are not replacing the card, install a filler panel.
Note -
78 Sun Netra T5440 Server • September 2015
The Sun Storage 6 Gb SAS PCIe RAID HBA, Internal must be installed in PCIe slot
for important cabling instructions.
XAUI 10 Gigabit Ethernet cards are supported in slots 4 and 5 only.
(Figure
Do not operate the server with empty slots.
"4.4 Cabling the Sun Storage 6 Gb SAS PCIe RAID
4-4).
(Figure 4-4).