Oracle Sun Netra T5440 Service Manual page 27

■
■
1.4.2.3 Service-Related Commands
Table 1-6
descriptions of all ALOM CMT CLI commands, issue the help command or refer to the
Integrated Lights Out Management 2.0 User's Guide.
Service-Related Commands
TABLE 1-6
ILOM Command
help [command]
set /HOST send_break_action=break
set /SYS/component
clear_fault_action=true
start /SP/console
show /SP/console/history
set /HOST/bootmode property=value
[where property is state, config, or
script]
stop /SYS; start /SYS
From the ILOM -> prompt, type start /SP/console.
From the ALOM-CMT sc> prompt, type console.
describes the typical ALOM CMT CLI commands for servicing a server. For
ALOM CMT Command
help [command]
break [-y][-c][-D]
■ -y skips the confirmation question.
■ -c executes a console command after
the break command completes.
■ -D forces a core dump of the Solaris OS.
clearfault UUID
console [-f]
■ -f forces the console to have read and
write capabilities.
consolehistory [-b lines|-e lines|-v] [-g lines]
[boot|run]
The following options enable you to specify
how the output is displayed:
■ -g lines specifies the number of lines to
display before pausing.
■ -e lines displays n lines from the end of
the buffer.
■ -b lines displays n lines from the
beginning of the buffer.
■ -v displays the entire buffer.
■ boot|run specifies the log to display
(run is the default log).
bootmode [normal] [reset_nvram]
[config=configname] [bootscript=string]
powercycle [-f]
Creating an ALOM CMT CLI Shell
Description
Displays a list of all available commands
with syntax and descriptions. Specifying a
command name as an option displays help
for that command.
Takes the host server from the OS to either
kmdb or OpenBoot PROM (equivalent to
a Stop-A), depending on the mode Solaris
software was booted.
Manually clears host-detected faults. The
UUID is the unique fault ID of the fault to
be cleared.
Connects you to the host system.
Displays the contents of the system's console
buffer.
Controls the host server OpenBoot PROM
firmware method of booting.
Performs a poweroff followed by poweron.
Chapter 1 • Server Diagnostics 27