Install Fb-Dimms - Oracle Sun Netra T5440 Service Manual

Install FB-DIMMs

Removing FB-DIMMs
FIGURE 4-21
Place the FB-DIMM on an antistatic mat.
6.
7. Repeat
8. Install filler panels in the empty FB-DIMM slots, if you are not replacing the FB-
DIMMs right away.
Install FB-DIMMs
Caution -
DIMMs or damage to the FB-DIMMs might occur. You must disconnect the power cables from
the system before performing this procedure.
Unpackage the replacement FB-DIMMs and place them on an antistatic mat.
1.
See
Tip -
configuring the FB-DIMMs.
2. Ensure that the ejector tabs are in the open position.
3. Line up the replacement FB-DIMM with the connector
104 Sun Netra T5440 Server • September 2015
Step 4 through Step 6
Ensure that all power is removed from the server before removing or installing FB-
"4.7 FB-DIMM Configuration Reference" on page 90
to remove any additional FB-DIMMs.
for information about
(Figure 4-22).