Oracle Sun Netra T5440 Service Manual page 28

Creating an ALOM CMT CLI Shell
ILOM Command
stop /SYS
start /SYS
set /SYS/PSx
prepare_to_remove_action=true
reset /SYS
reset /SP
set /SYS keyswitch_state=value
normal | stby | diag | locked
set /SYS/LOCATE value=value
[Fast_blink | Off]
{No ILOM equivalent.)
show faulty
{No ILOM equivilient.)
28 Sun Netra T5440 Server • September 2015
ALOM CMT Command
The -f option forces an immediate
poweroff. Otherwise the command attempts
a graceful shutdown.
poweroff [-y] [-f]
■ -y enables you to skip the confirmation
question.
■ -f forces an immediate shutdown.
poweron [-c]
■ -c executes a console command after
completion of the poweron command.
removefru PS0|PS1
reset [-y] [-c]
■ -y enables you to skip the confirmation
question.
■ -c executes a console command after
completion of the reset command.
resetsc [-y]
■ -y enables you to skip the confirmation
question.
setkeyswitch [-y] value
normal | stby | diag | locked
■ -y enables you to skip the confirmation
question when setting the keyswitch to
stby.
setlocator value
[on | off]
showenvironment
showfaults [-v]
showfru [-g lines] [-s | -d] [FRU]
■ -g lines specifies the number of lines to
display before pausing the output to the
screen.
Description
Powers off the host server.
Powers on the host server.
Indicates if it is okay to perform a hot-swap
of a power supply. This command does
not perform any action. But this command
provides a warning if the power supply
should not be removed because the other
power supply is not enabled.
Generates a hardware reset on the host
server.
Reboots the service processor.
Sets the virtual keyswitch.
Turns the Locator LED on the server on or
off.
Displays the environmental status of the host
server. This information includes system
temperatures, power supply, front panel
LED, hard drive, fan, voltage, and current
sensor status.
Displays current system faults.
Displays information about the FRUs in the
server.