Installing The Dp (Option) - Kyocera KM-2550 Service Manual

1-3-4

Installing the DP (option)

<Procedure>
1. Remove the original holder and remove the
two screws from the rear top cover.
2. Pass the two pins through the screw holes
of the rear top cover and attach them to the
lower frame.
3. Place the DP on the MFP by fitting the pins
into the holes at the hinge sections of the
DP and sliding them toward the front side.
4. Secure the DP with the two TP Taptite chro-
mate screws M4 x 10 and the two screws
that have been removed in step 1.
Pin
Screw
Figure 1-3-10
DP
Pin
Hole
Figure 1-3-11
TP Taptite
TP Taptite
chromate
chromate
screw M4 x 10
screw M4 x 10
Screw
DP
Figure 1-3-12
2FT
Pin
Screw
Pin
Hole
Screw
1-3-9