Cisco ASA 5505 Configuration Manual page 1625

Chapter 71 Configuring Logging
Adding or Editing Syslog Server Settings
To add or edit syslog server settings, perform the following steps:
Step 1 Choose the interface used to communicate with the syslog server from the drop-down list.
Enter the IP address that is used to communicate with the syslog server.
Step 2
Choose the protocol (either TCP or UDP) that is used by the syslog server to communicate with the
Step 3
adaptive security appliance.
Enter the port number used by the syslog server to communicate with the adaptive security appliance.
Step 4
Check the Log messages in Cisco EMBLEM format (UDP only) check box to specify whether to log
Step 5
messages in Cisco EMBLEM format (available only if UDP is selected as the protocol).
Check the Enable secure logging using SSL/TLS (TCP only) check box to specify that the connection
Step 6
to the syslog server is secure through the use of SSL/TLS over TCP, and that the syslog message content
is encrypted.
Click OK to complete the configuration.
Step 7
Generating Syslog Messages in EMBLEM Format to Other Output Destinations
To generate syslog messages in EMBLEM format to other output destinations, perform the following
steps:
Path
Configuration > Device Management > Logging >
Logging Setup
OL-20339-01
Purpose
Sends syslog messages in EMBLEM format to output
destinations other than a syslog server, such as Telnet or SSH
sessions.
Cisco ASA 5500 Series Configuration Guide using ASDM
Configuring Logging
71-17