Cisco ASA 5505 Configuration Manual page 1618

Configuring Logging
Editing Syslog ID Settings
To change syslog message settings, perform the following steps:
The Syslog ID(s) field is display-only. The values that appear in this area are determined by the entries
Note
you chose in the Syslog ID table, located in the Syslog Setup pane.
Check the Disable Message(s) check box to disable messages for the syslog message ID(s) displayed in
Step 1
the Syslog ID(s) list.
From the Logging Level drop-down list, choose the severity level of messages to be sent for the syslog
Step 2
message ID(s) displayed in the Syslog ID(s) list. Severity levels are defined as follows:
•
•
•
•
•
•
•
•
Note
Click OK to close this dialog box.
Step 3
Including a Device ID in Non-EMBLEM Formatted Syslog Messages
To include a device ID in non-EMBLEM formatted syslog messages, perform the following steps:
Check the Enable syslog device ID check box to specify that a device ID should be included in all
Step 1
non-EMBLEM formatted syslog messages.
To specify which to use as the device ID, choose one of the following options:
Step 2
•
•
•
•
Click OK to close this dialog box.
Step 3
Cisco ASA 5500 Series Configuration Guide using ASDM
71-10
Emergency (level 0, system is unusable)
Alert (level 1, immediate action is needed)
Critical (level 2, critical conditions)
Error (level 3, error conditions)
Warning (level 4, warning conditions)
Notification (level 5, normal but significant conditions)
Informational (level 6, informational messages only)
Debugging (level 7, debugging messages only)
Using a severity level of zero is not recommended.
Hostname of the adaptive security appliance
Interface IP address
Choose the interface name that corresponds to the specified IP address from the drop-down list.
String
In the User-Defined ID field, specify an alphanumeric, user-defined string.
Context
Chapter 71 Configuring Logging
OL-20339-01