Panasonic KX-TD816 Programming Manual page 76

2.2 System Programming
Default
LV-MSG – H; GETMSG – *H; AA-SVC – #8; VM-SVC – #6
Programming
1.
Enter 114.
Display: 114 VM DTMF CMD
2.
Press NEXT to programme the LV-MSG command.
To programme another command, keep pressing NEXT until the desired command is
displayed.
Display example: LV-MSG:H
3.
Enter a DTMF signal number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new number.
4.
Press STORE.
5.
To programme another selection, keep pressing NEXT or PREV until the desired selection
is displayed.
6.
Repeat steps 3 through 5.
7.
Press END.
Conditions
• A command signal number can have a maximum of 16 digits, consisting of 0 through 9, ,
#, FLASH and PAUSE.
• The FLASH button is available only for LV-MSG and GETMSG commands to store "H"
which means "Home Position".
• If "H" is stored for "LV-MSG", a mailbox number programmed in programme [609] Voice
Mail Access Codes or an extension number will be sent to the VM port (Follow On ID
function). If certain codes are required before and after the ID code, insert "H" between the
codes, as "aaaHbbb". If nothing is stored, it will operate as "H".
• If " H" is stored for "GETMSG", a mailbox number programmed in programme
[609] Voice Mail Access Codes or an extension number will be sent to the port succeeding
the " ".
Features Guide References
Voice Mail Integration for Inband
76 General Programming