Panasonic KX-TD816 Programming Manual page 16

1.3 Programming Methods
Going to another programme address
After pressing STORE, you can go to another programme with either of the following two
methods:
a)
To go to the next larger programme address:
Press Soft 1 (SKP+) or VOLUME
clockwise direction.
To go to the next smaller programme address:
Press SHIFT + Soft 1 (SKP–) or VOLUME
clockwise direction.
b)
To go to a specific programme address:
Press END, then enter the programme Address.
Method (1) is useful when you want to perform a series of programmes consecutively. For
example, to change the programming in addresses [0XX], use this method. You can move from
[000] to [001], from [001] to [002], and so on by pressing the SKP+ or VOLUME . You can
move in reverse order from [008] to [007], etc. by pressing the SKP– or VOLUME .
This method can also be used to move between neighboring programme groups: For example,
you can move between the programme addresses of the largest [0XX] and [100], the largest
[1XX] and [200], and so on. Also, you can move between the smallest programme address
[000] and the largest one [9XX].
Method (2) is useful when you wish to jump to another programme address. For example, you
have just finished with programme [006] and now you want to go to programme [301]. Neither
SKP+ / VOLUME
END and enter 301.
Note
The following programming instructions assume that you have already entered the
programming mode and that you will use Method (b).
Confirming the entries
You may review the stored programming without making any changes.
Going back to the operation mode
Two ways are available to go back to the operation mode:
a)
Lift the handset while in programming mode.
b)
When the Initial Message: SYS-PGM NO?
PAUSE) button. (To display the Initial Message, press END.)
16
(DOWN) or rotate the Jog Dial in the counter-
nor SKP–/VOLUME
(UP) or rotate the Jog Dial in the
is convenient in this case. So you should press
is displayed, press the PROGRAM (or
Programming Instructions