Parameters; Fax Parameters - Ricoh D127 Service Manual

Dedicated Transmission Parameters

5.4.2 PARAMETERS

Fax Parameters

The initial settings of the following fax parameters are all FF(H) - all the parameters are disabled.
Switch 00
FUNCTION AND COMMENTS
ITU-T T1 time (for PSTN G3 mode)
If the connection time to a particular terminal is longer than the NCU parameter setting,
adjust this byte. The T1 time is the value stored in this byte (in hex code), multiplied by 1
second.
Range:
0 to 120 s (00h to 78h)
FFh - The local NCU parameter factory setting is used.
Do not program a value between 79h and FEh.
Switch 01
No
Tx level
Bit4 Bit3
0 0
0 1
0-4
0 1
1 1
D127/D128
FUNCTION
Bit2 Bit1 Bit0
0 0 0
0 0 0
1 1 1
1 1 1
If communication with a particular
remote terminal often contains
errors, the signal level may be
inappropriate. Adjust the Tx level
0
for communications with that
–8
terminal until the results are
better.
–15
If the setting is "Disabled", the
NCU parameter 01 setting is
used.
Disabled

Do not use settings other
than listed on the left.
5-84
COMMENTS
SM Appendix