Ricoh D127 Service Manual page 521

Hide thumbs Also See for D127:

Table of Contents

5.3 NCU PARAMETERS

The following tables give the RAM addresses and the parameter calculation units that the

machine uses for ringing signal detection and automatic dialing. The factory settings for each

country are also given. Most of these must be changed by RAM read/write (SP2-101), but

some can be changed using NCU Parameter programming (SP2-103); if SP2-103 can be

used, this will be indicated in the Remarks column. The RAM is programmed in hex code

unless (BCD) is included in the Unit column.

Country/Area code for NCU parameters

Use the Hex value to program the country/area code directly into this

address, or use the decimal value to program it using SP2-103-001

NCU Parameters

Chapters

Table of Contents