Ricoh D127 Service Manual page 57

19. Pass the grounding wire (Long) [18] through the hole [17] to the rear of the copier.
20. Mount the copier on two of the paper tray units [19].
21. Put the heater harness (Long) in the hole [20].

Be sure to put the heater harness (Long) in the hole on keeping the end of the heater
harness (Long) horizontally long. This makes insertion easy.
22. Pass the support bracket between the copier and the heater harness (Long) on keeping the
end of the heater harness (Long) in the hole.

To do step 22 easily, be sure not to pass the heater harness (Long) completely thorough
the hole [20] at the step of 21.
23. Attach the edge saddle [21] to the support bracket.
24. Attach the heater harness (Long) and the grounding wire (Long) through the edge saddle as
shown.
25. Pass the grounding wire (Long) through the hole.
26. Pull the heater harness (Long) and the grounding wire (Long) to the paper tray unit side.
27. Remove the hole cover [22] of the upper paper tray unit. (
SM
x 1)
2-25
Paper Tray Unit Heater
D127/D128