Copier
15. Pull out the paper tray, and remove the tape securing the end fence in the compartment.
16. Push the bottom plate down, and then load the paper.
17. Adjust the side fences. If you load paper shorter than A4, set the end fence in the correct
position.
18. Push the tray back into the copier.
19. Attach the appropriate tray number decal and paper-size decal to the paper tray [N].
20. Install optional units (if any).
21. Attach the ferrite core [O] to the end of the network cable [P] when connecting the cable.
D127/D128
2-8
SM