Ricoh D127 Service Manual page 56

Paper Tray Unit Heater
12. Remove the support bracket [12] ( x 3).
13. Attach the heater harness (Long) [13] to the connector [14] on the board.
14. Attach the clamp (Large) [15]
15. Lead the heater harness (Long) [13] through the clamp (Large) [15] toward inner side of the
copier as shown.
16. Attach the clamp (Large) [16].
17. Pass the heater harness through the hole [17] to the rear of the copier.
18. Attach the grounding wire (Long) [18] ( x 1, Washer x1, Spring washer x1)
D127/D128 2-24 SM