Ricoh D127 Service Manual page 429

Code Meaning
6-09 G3 ECM - ERR received
G3 ECM - error frames still
received at the other end
6-10
after all communication
attempts at 2400 bps
V.21 flag detected during
6-21 high speed modem
communication
The machine resets the
sequence because of an
6-22
abnormal handshake in the
V.34 control channel
V.21 signal not stopped
6-99
within 6 s
SIP user name registration
13-17
error
13-18 SIP server access error
SIP authentication
13-24
password error
14-00 SMTP Send Error
SM Appendix
Suggested Cause/Action

Check for a noisy line.

Adjust the tx levels of the communicating
machines.

See code 6-05.

Check for line noise.

Adjust the tx level (use NCU parameter 01 or
the dedicated tx parameter for that address).

Check the line connection.

Defective remote terminal.

The other terminal may be defective or
incompatible.

Check for line noise.

If the same error occurs frequently, replace the
FCU.

Defective remote terminal.

Replace the FCU.

Double registration of the SIP user name.

Capacity for user-name registration in the SIP
server is not sufficient.

Incorrect initial setting for the SIP server.

Defective SIP server.

The input password for the authentication
does not match the password registered in the
SIP server.

Error occurred during sending to the SMTP
server. Occurs for any error other than 14-01
to 16. For example, the mail address of the
system administrator is not registered.
4-11
Fax Error Codes
D127/D128